Analysis of Traction Properties of Massey Ferguson 7475 Tractor on Selected Deformable Surfaces
DOI:
https://doi.org/10.1515/agriceng-2016-0014Keywords:
traction force, adhesion ratio, towing power, driving tyreAbstract
The research concern selected traction properties of Massey Ferguson 7475 wheeled tractor, which were carried out on various deformable surfaces i.e. soil: after ploughing, sodded and with rye fore crop. The impact of driving speed on tractive power and force with 2WD and 4WD drive was investigated. Physical and chemical properties of soil during testing were characterised by moisture, compactness and maximum shearing stresses. Studies on traction properties were carried out with the use of two tractors: Massey Ferguson 7475 and New Holland 5040. During measurements, tractors were connected with a tow rod, where a strain force transducer was mounted. The stand enabled also measurement of theoretical speed. As a result of analyses of the obtained results, characteristics of tractive force and towing power as a function of slip were made. The tests confirmed that the use of four-wheel drive is unjustified because it improves these tractive parameters of a tractor. It was reported that the maximum force and towing power are generated for the lowest values of slip which is equal to 0.1 on the sodded surface. However, value of this power is the lowest in comparison to other surfaces. The highest value of the adhesion coefficient was reported on soil with rye fore crop.Downloads
Published
2016-07-24
Issue
Section
Articles
How to Cite
Analysis of Traction Properties of Massey Ferguson 7475 Tractor on Selected Deformable Surfaces. (2016). Agricultural Engineering , 20(1), 137–145. https://doi.org/10.1515/agriceng-2016-0014
Most read articles by the same author(s)
- Krzysztof Lejman, Rafał Fedorczuk, Application of FKM Calculation Algorithm for Determination of Degree of Utilization of A Milk Tank Wall , Agricultural Engineering : Vol. 22 No. 4 (2018)
- Zygmunt Owsiak, Krzysztof Lejman, Krzysztof Pieczarka, Tomasz Sekutowski, The Impact of Shearing and Flexibility of Cultivator Tines on the Vertical Forces Value , Agricultural Engineering : Vol. 22 No. 2 (2018)
- Marian Wiercioch, Adam Luberański, Krzysztof Lejman, Małgorzata Fugol, Hubert Prask, Shaping Teat Suction Forces of Liners with Varied Structure of Rubber Core , Agricultural Engineering : Vol. 23 No. 1 (2019)
- Zygmunt Owsiak, Krzysztof Lejman, Krzysztof Pieczarka, Tomasz Sekutowski, Effect of Cutting Speed and Depth on the Course of Resultant Force Acting on a Cultivator Tine , Agricultural Engineering : Vol. 20 No. 1 (2016)
- Krzysztof Lejman, Zygmunt Owsiak, Krzysztof Pieczarka, Tomasz Sekutowski, Vertical Forces Acting on Cultivator Tines in the Aspect of Shearing Speed and Flexibility of Tines , Agricultural Engineering : Vol. 22 No. 2 (2018)